Tuesday, January 13, 2015

Day 11: CADing and Printing

We fixed a few things with the prototype robot, but most of the day was spent CADing.

We also have our 3D printer making very accurate parts out of polycarbonate filament (Lexan).


This part is piece for our four bar that will allow us to tilt back the totes and recycling containers while we are carrying them.

We should be getting drive train components in the next couple days so robot progress will speed up then.

- Spectrum

“Your work is to do the work, not to do your job. Your job is about following instructions; the work is about making a difference. Your work is to ship. Ship things that make change.” - Seth Godin

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.